Power Flushing

Power Flushing with Kamco CF90

Power Flushing is a process by which heating systems are forcibly cleansed using water at high velocity, but low pressure, so that no physical damage is caused to the system.The process can be made even more effective with the addition of powerful cleaning agents (CHEMICALS)

The objective is to restore systems with circulation and boiler noise problems (caused by sludge and corrosion deposits) to optimum operation.

Power flushing removes these deposits and the problems that they cause....
It is prudent to power flush a heating system immediately before fitting a new boilerto an existing system toprevent possible future problems.Many systems are found to contain corrosion and sludge,even if no flow problems have yet shown themselves.

Existing debris is often mobilised by alterations to the system/piping and the increased efficiency of thenew boiler, and may then accumulate in the boiler heat exchanger, causing noisy operation, reduced efficiency and, in extreme circumstances, failure of the boiler. The high efficiency and compactness of modern boilers, developed to minimise fuel costs and pollution, means that they are more susceptible to problems caused by debris in the system water.

The CLEARFLOW

Power flushing process is a versatile, easy to use and highly effective method of flushing heating systems. By utilising CLEARFLOW system flushing pumps, heating systems can be purged of sludge, scale and corrosion deposits with minimal dismantling and disruption. request power flushing when.

  • Noise from boiler
  • poor or no hot water
  • high fuel bills
  • boiler failure
  • can see cold spots on radiator
  • blocked radiator
  • radaitor frequently needing venting or bleeding
  • radiators slow to heat up
  • heating circulation problems
  • blocked inoperative or leaking radiator valves

The CLEARFLOW power flushing pump is simply connected into the heating system,either across standard circulator pump couplings, across the tails of one radiator, or wherever most practicable. The powerful flow, combined with instantaneous flow reverser device, will dislodge and mobilise deposits and corrosion which resist traditional system cleaning methods.

Once the corrosion and sludge deposits have been loosened and mobilised, fresh clean water is forced through the heating system, pushing the contaminated water out through a full bore dump valve to waste. During the CLEARFLOW process, radiators are individually flushed, without removing or disconnecting them from the system, by directing the full output of the pump through each radiator separately.

At the end of the flushing process, the system contains fresh clean water and reinstatement of the system to normal operation takes only a few minutes.